[V7.6.9]Button "Finishing up" is buggy in WebControl

[HB9EVT]

Hi

I hope this is the correct place to report a bug. If not, please move this article to the correct place.

In the Web Control Client is - when folding is running - the big red button "Stop Folding". If you press this button, you get the followin choice:
- green Button "Finishing up, then stop"
- red Button "Stop now"

The red Button "Stop now" is working. Folding stops.

But teh green Button "Finishing up, then stop" shows no reaction. Seems to be buggy.

In the "Client Advance Control" is the grey button "Finish" working proberly. So the bug is only in the Web Control Client.

Pepe

[Joe_H]

There was another report of this problem, and it has been reported on the development site - https://github.com/FoldingAtHome/fah-issues/issues/1415.

And yes, this is the right place to report such problems.

[HB9EVT]

thanks @Joe

[comixgoddess]

I have encountered the same issue - macOS Catalina 10.15.4 running F@h version 7.6.9. I normally use the Advanced Control Panel so not a huge deal for me.

[Bratfalken]

Problem is still there in 7.9.13, which means there are WU's that never get done properly, just sent out in vain as the only way to stop is to do it in the middle of a WU. Now, my 3700X with it's 2060 doesn't need more than a few hours to do a WU, but I bet there are slower computers that doesn't finish in time because of this?

[Not_a_Number]

I have noticed this behavior in 7.9.13. I upgraded from 7.6.9 mainly in hopes this would be fixed.

Not a big deal as you can just open the advanced client and set the status / action to "Finish". You can even set each slot individually.

[Bratfalken]

I have noticed this behavior in 7.9.13. I upgraded from 7.6.9 mainly in hopes this would be fixed.

Not a big deal as you can just open the advanced client and set the status / action to "Finish". You can even set each slot individually.

Yes, I finally understood the button in the non HTML version, It works as it should, maybe just a notion on the HTML button that you have to use the advanced clients rightmost button would be enough?