Possible to just get a few hours of work?
Posted: Sat Jan 11, 2025 5:38 pm
I'm sometimes starting computers to get some extra heat when temp has gone down more than i desire.
But sometimes one get work units that take 3 days at full speed, and my plan is usually just to run it for like 12 hours I try to make sure to finish units i have been assigned.
Would it be possible to set an aproximated amount of work or part of a work unit so i don't have to waste a unit at some point?
Would be extra bad to do it on a big work unit.
I guess someone depend on the work being completed, no good if i then hog a unit until next time i need some heat.
I really want to make sure i don't cause problems for the projects
But sometimes one get work units that take 3 days at full speed, and my plan is usually just to run it for like 12 hours I try to make sure to finish units i have been assigned.
Would it be possible to set an aproximated amount of work or part of a work unit so i don't have to waste a unit at some point?
Would be extra bad to do it on a big work unit.
I guess someone depend on the work being completed, no good if i then hog a unit until next time i need some heat.
I really want to make sure i don't cause problems for the projects