ARM CPUs supported

Foliant · Post by **Foliant** » Mon Dec 28, 2020 11:26 pm

With the ARM-Client officialy suported it would make sense to have a forum dedicated to.

Now, after christmas Im awaiting some ARM Hardware to arrive in my Workshop and i may experiment a while.
Infos about ARM is widely spread over the existing Forums.
Posting in "unsupported distros" doesnt feel right to seek and share experience.

May we please have a Place for the New ARM-Client?

Post by **PantherX** » Wed Dec 30, 2020 2:40 am

Foliant wrote:With the ARM-Client officialy suported it would make sense to have a forum dedicated to.

Now, after christmas Im awaiting some ARM Hardware to arrive in my Workshop and i may experiment a while.
Infos about ARM is widely spread over the existing Forums.
Posting in "unsupported distros" doesnt feel right to seek and share experience.

May we please have a Place for the New ARM-Client?

I think we already have one... bruce created this shortly after the announcement: viewforum.php?f=112

Foliant · Post by **Foliant** » Wed Dec 30, 2020 8:17 am

If it was created a time ago it maybe was invisible to normal users?

Bruce messaged me on Tue Dec 29, 2020 11:25 pm with a quote of my above question and a "Done".
After that i did see a new, empty, forum under current software.

Post by **PantherX** » Wed Dec 30, 2020 9:12 am

Foliant wrote:If it was created a time ago it maybe was invisible to normal users?...

I opened up the Board index in an incognito window and I can see "Software for ARM hardware" so would assume that it is visible to all.

Foliant · Post by **Foliant** » Wed Dec 30, 2020 9:55 am

Yes, it is.
I bet it wasnt until yesterday.

Post by **bruce** » Thu Dec 31, 2020 4:56 pm

PantherX wrote:I think we already have one... bruce created this shortly after the announcement: viewforum.php?f=112

What happens if a "normal user" clicks the link he gave?

Neil-B · Post by **Neil-B** » Fri Jan 01, 2021 7:15 pm

I am a normal user and when I click the link I get to the "Software for ARM hardware" forum page

Post by **bruce** » Fri Jan 01, 2021 8:44 pm

So we're good to go ...and have been for about a week.

Folding Forum