Adding Team Number
Moderators: Site Moderators, FAHC Science Team
-
snerd
- Posts: 19
- Joined: Tue Apr 12, 2011 8:49 pm
- Hardware configuration: Dell Studio XPS Intel Core i7 870 @ 2.93ghz 12gb Windows 7 Ultimate 64-bit nVidia GTS-240 1024mb
- Location: Oklahoma
- Contact:
Adding Team Number
I created a team and entered the number in my client.cfg but when I check later it's not there, not saving or disappearing. How to enter team number using SMP2 console client as service?
Re: Adding Team Number
A service does, in fact, support team numbers.
What's never clear is how to change the configuration of a service once it has been started.
Stop the service. Run the same interactive client that you used originally to configure the service (with -configonly) and make the change. Restart the service.
What's never clear is how to change the configuration of a service once it has been started.
Stop the service. Run the same interactive client that you used originally to configure the service (with -configonly) and make the change. Restart the service.
Posting FAH's log:
How to provide enough info to get helpful support.
How to provide enough info to get helpful support.
-
snerd
- Posts: 19
- Joined: Tue Apr 12, 2011 8:49 pm
- Hardware configuration: Dell Studio XPS Intel Core i7 870 @ 2.93ghz 12gb Windows 7 Ultimate 64-bit nVidia GTS-240 1024mb
- Location: Oklahoma
- Contact:
Re: Adding Team Number
Thanks, that did it.bruce wrote:A service does, in fact, support team numbers.
What's never clear is how to change the configuration of a service once it has been started.
Stop the service. Run the same interactive client that you used originally to configure the service (with -configonly) and make the change. Restart the service.