Folding Forum

I don't see any screenshot image there, could you try that again? If you have the router set up, you'll also need to figure the F@h software at your dad's place. Click "control" in the upper-left corner, go under the Remote Access tab, and add a password/passphrase into the first section....

You're poking around in the right places. You will first need a couple pieces of information: 1) the IP address for both your home and your dad's home. At each location, open up DuckDuckGo or Google and type in "what is my IP address" and it will directly tell you. Write these down. 2) Yo...

Well I prefer to have the FAH client connected rather than teamviewer because it's more convenient to have it show up in FAHControl rather than going through another window. And the fact that I have to go through the reconnection process every time teamviewer closes, such as during a computer restar...

Hey there, I recently worked through how to connect a client to my main computer on a local, home internet network. I'm still new to this IP and network config stuff though, so I was wondering if someone could give me a step-by-step guide on how to remote access over the internet rather than on a lo...

Do you have (written) permission to use the work computer for FAH? (See the EULA and probably the terms of your employment.) I will go and check with 'em if its fine but most likely they'll approve it in these extenuating circumstances, and FAH allows me to directly contribute to a cure -- otherwis...

Ah, I think you left off the "127.0.0.1" part in the Allow field in the Remote Access tab. As a result, FAHControl on the same computer won't be able to connect. The Allow field should be set to "127.0.0.1 10.0.0.0/24" so that FAHControl on the same computer, and FAHControl on a...

I'm still having weird problems. It is still stuck on "connecting" even after I followed the above steps with the IP addresses. In addition, as soon as I configure the remote access tab on computer B and restart FAHControl, I no longer have access to any config tabs besides "connectio...

Thanks for responding. I followed the steps to the best of my abilities but computer A's FAHControl still says that computer B is connecting. I must be putting in the wrong IP addresses. Could you go into more detail about which exact IP Addresses I need to put into computer B's remote access config...

Hey there,

Still relatively new to this. I'm planning on setting up my second computer for FAH but I am still utterly confused on how to use remote access such that I can monitor both computers on my main computer. What are the exact steps to connect a second machine with remote access? Thanks.

One of my completed WUs has been stuck on "Send Results" with 42 attempts already, causing it to lose over 80% of its credit value. Any way to fix this client-side or is it a problem with the server? Here's a snippet of what the logs say: 20:05:39:WU01:FS01:Upload 57.56% 20:05:45:WU01:FS01...

Hey there. I just installed F@H today, so sorry if this question is obvious or has already been answered. My CPU is getting WUs and is running wonderfully, but my GPU is still idle with no WU assigned to it. Is this normal? I attached the logs below. *********************** Log Started 2020-04-12T19...